I have a DTS 500 expert (with the green cover) – I can provide the serial number via PM if needed.
Today when trying to open the gate, I received the 4 beeps indicating a blown fuse. I check and repaired the fuse problem (Fuse was blown), however the gate now has a different issue where it doesn’t stop itself or “re-calibrate" correctly.
Normally to “re-calibrate” the motor encoder you open it about a meter and press the button. The motor closes very slowly up to the limit then opens again up to the limit.
What is happening now is that when I press the button the motor runs full speed until it hits the metal stop on the fence, the motor doesn’t seem to cut out and needs to be “stopped” by removing power.
The motor doesn’t stop even when manually pushing the limit switch
I have noticed the following:
The “pulse” light does indeed flash when manually turning the motor which seems to indicate the encoder is working to some extent
The “open” and “closed” lights do go on when manually pushing the limit switch.
Is this a problem / issue which you are aware of? Perhaps a PCB issue? Can it be repaired or does something need to be replaced?
Note I did send an email with this as well prior to noticing this forum
if correct the only remedy is to return the PCB to one of our distributors for repair or replacement.
Who is online
Users browsing this forum: No registered users and 1 guest