Page 1 of 1

DTS Octo Remote

Posted: Thu Jan 18, 2018 5:52 pm
by StevenH
How do you program these remotes. I have a Magic Lift garage door motor.

Re: DTS Octo Remote

Posted: Fri Jan 19, 2018 9:01 am
by G.Mitchell
The Remote will have to be programmed into the GDO's receiver. You will need the motors instruction manual for the correct remote "learning" procedure.

Re: DTS Octo Remote

Posted: Sat Feb 16, 2019 12:31 pm
by cobbers
i have a gate motor and separate receiver and two remotes supplied withthe receiver and two dts 5 button remotes. the two remotes supplied with the receiver work just fine but the two dts 5 button remotes wont program. one burns the led continiously when a button depressed and the other one led flashes rapidly. any advice, i dont seem to be able to find any remote manual or other instructions on your site.

the receiver instructions are very simple, hold down remote button, short "learn" for few seconds and its done. but what if it is'ent done?

Re: DTS Octo Remote

Posted: Mon Feb 18, 2019 8:22 am
by CHANTELLE
Good morning,
Could you please advise us which gate motor you have as well as which receiver.
Thank you