Solar Panel

Post Reply
jabulanid
Posts: 2
Joined: Sun Feb 10, 2019 1:16 pm

Solar Panel

Post by jabulanid » Sun Feb 10, 2019 1:42 pm

I recently purchased a new DTS expert gate motor, the motor is stated solar ready, my question is, where do I cable the solar panel, do I need a solar control charge unit and inverter? If not, where do I connect the solar on the motor?

Solar panel uses two (2) wires (positive and negative) and AC uses three( 3) wires. (LEN). Can you please illustrate on the picture.

Regards

CHANTELLE
Posts: 20
Joined: Thu Jan 24, 2019 11:50 am

Re: Solar Panel

Post by CHANTELLE » Mon Feb 11, 2019 7:49 am

Good morning Sir,

The two solar panel wires will be connected to your 16VAC on the PCB.
Disconnect the red wire that is currently connected on the 16VAC from your transformer and then you can connect your solar panel wires there.
Your 220V input LEN will remain open

jabulanid
Posts: 2
Joined: Sun Feb 10, 2019 1:16 pm

Re: Solar Panel

Post by jabulanid » Mon Feb 11, 2019 12:22 pm

What size of solar panel is suitable for the motor?

CHANTELLE
Posts: 20
Joined: Thu Jan 24, 2019 11:50 am

Re: Solar Panel

Post by CHANTELLE » Mon Feb 11, 2019 3:04 pm

Good afternoon sir,

We recommend a 12V 50W for normal domestic use

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest